The Insert tab is shown in the figure below.
Insert Tab
This menu enables you to add new folders and components to the project. Ribbon menus, shown in the figure below, are utilised in the Insert tab to logically group components together in accordance with their relevant locations in the project creation process. A total of five buttons are ribbon menus, namely Line, Stinger, Vessel, Model and Load.
Insert Tab with Ribbon menu selected
The full list of components available on the Insert tab is provided in the table below, which is sorted based on the groups or ribbon menus in which the components are located. Note that the Support and Tensioner components appear in both the Stinger and Vessel ribbon menus and so these components are shown twice in the table in the interest of clarity.
Table: Insert Tab Buttons
Group / Ribbon Menu |
Button |
Function |
Base |
Create a folder. |
|
Create a Material component. |
||
Line |
Create a Pipe Section component. |
|
Create a Cable component. |
||
Create a Flex Joint component. |
||
Create a Structure component. |
||
Create a Tapered Stress Joint component. |
||
Create an Ancillary component. |
||
Create a Connection component. |
||
Create a Spring component. |
||
Create a Line component. |
||
Stinger |
Create a Support component. |
|
Create a Tensioner component. |
||
Create a Stinger Section component. |
||
Create a Stinger component. |
||
Vessel |
Create an RAO Conversion component. |
|
Create a Vessel Motion component. |
||
Create a Vessel Offset component. |
||
Create a Support component. |
||
Create a Tensioner component. |
||
Create a Vessel component. |
||
Model |
Create a Seabed component. |
|
Create an Internal Fluid component. |
||
Create a Sheave component. |
||
Create a Buoy component. |
||
Create a Model component. |
||
Load |
Create a Current component. |
|
Create a Wave component. |
||
Create an Axis System component. |
||
Create a Load component. |
||
Fatigue |
Create an S-N Curve component. |
|
Postprocessing |
Create a Custom Postprocessing component. |
|
Analysis |
Create an Analysis component. |
|
Create a Batch Analysis component. |