Example 13 - Pipe-in-Pipe |
|
Example 13 - Pipe-in-Pipe |
|
These articles describe the installation of a pipe-in-pipe line. It is similar in many respects to a standard S-Lay scenario, though slightly more complex in that the installed pipeline comprises a pipe-in-pipe configuration.
It is divided into the following sections:
•‘Introduction’ gives an overview of the example.
•‘Example Files’ gives the location of all of the files necessary to run the example.
•‘Components’ describes the creation of the various components and presents the data required.
•‘Model Component’ describes how the model is assembled together.
•‘Analysis Component’ describes how the analysis is set up and run.
•‘Results’ examines the results obtained.